Glossary
Cross base
Basic stand in the shape of a cross – uses one pole to support media.
Twinbase
A solid 60cm bar is positioned between the two feet to enable support of wider graphics – uses two poles to support media.
Twinbase XL
As per twinbase but 100cm bar used between feet to enable support of larger media – again uses two poles.
Square Plate
A flat, more permanent alternative to the cross base.
Twin plate
A flat, more permanent alternative to the twinbase.
FLEX-clip top
This clip attaches the horizontal graphic bar to the vertical poles but instead fits over the top of the vertical pole preventing it sliding down when heavy media is used.
FLEX-clip bottom
Used at the bottom of single sided displays. Slides over the pole and can be positioned anywhere or fixed using the small grub screw to the rear.
Grip clip
Used at the bottom of double sided displays connecting a horizontal graphic bar to the vertical poles. Uses silicone strips to keep it in place.
Single ceiling clip
Use this eyeleted clip with suspension wires to hang a single sided banner.
Double ceiling clip
Use this eyeleted clip with suspension wires to hang a double sided banner.
Double grip clip
Allows double sided Displays to be created. Clips over the back of a grip clip.
Wall mounting kit
Includes screws, plugs and necessary connectors to wall mount a graphic. Use one kit every 0.6m width.
Classic pole XL
Comes in various heights and in 1, 2 or 3 sections depending on portability required. Creates the Display height.
Telescopic pole
Simple twist and lock mechanism allowing variable height between 135cm and 250cm.
Classic bar
Aluminium extrusion for mounting media. Can be used with FLEX-tape or Hook & Loop tape depending upon media being used.
Snaplock bar
Aluminium extrusion with mechanical action. Used for mounting media (without the need for tape) by trapping within its jaws.
Flexible Display connector
Allows two single Displays of the same height to be joined at an angle.
Display connector clip
Use this clip to span two displays to either connect them or to stabilise a widescreen joint when it is used for straight displays.
Wide screen joint
Use this to make Displays greater than 2m wide with one piece graphic drops. It allows graphics to be used straight or angled and enables them to be folded away compactly.